Topic starter
So I was putting the bike back in the car after a ride this evening and managed to round off the 5mm bolt at one end of the 20mm axle (White Brothers' forks btw) 😡 they were second hand, and the hole had been a little rounded off by the previous owner - but I'd hoped it would last.
Are the bolts on 20mm thru-axles generally the same diameter & thread, etc. Or am I going to have a pig of a time ordering one from the states?
Posted : 30/12/2010 12:20 am
Careful use of a needle file can open them up to take a 6mm key, done it a couple of times to rescue cack-handed moments.
Posted : 30/12/2010 3:00 am
Topic starter
Cool. Will try!
Posted : 30/12/2010 3:37 am
