Forum menu
Anyone know the reach measurement of an 18", 2011 Blue Pig? I found some numbers over on MTBR (407mm), but not sure if they pertain to the 2011 or the previous incarnation.
Don't know the reach but the ETT was 597mm if that's any good to you.
Yeah, got the spec sheet that has that on it. No reach (or stack) there unfortunately.
Is that frame the same as a Mk1? If so I can go get a measurement if you tell me where to measure from, and to.
Ben.
I think the geometry is the same as the mk1, but not sure. I have the bike and have tried measuring it myself, but the measurement is a good 20mm out from what I'd expect it to be, so I must be doing it wrong. Hence why looking for the official figure. Might take the wheels off and try it again. Apparently, for every 1 degree your floor is off level when measuring, that affects the measurement by about 1cm.
Just foung this [url= http://velonews.competitor.com/2012/05/bikes-and-tech/technical-faq/technical-faq-setting-your-bikes-up-identically_216035 ]Measuring reach[/url], so gonna give that a try.
Waiting on a reply from Ragley, but that could take a while.
Haha ok!
Just so you know, I'm trying to compare it to another frame, so I know if it will feel similar, or not...
And the other frame is ????