- This topic has 11 replies, 8 voices, and was last updated 9 years ago by .
-
2013 Lapierre Spicy 10 speed gear issues…
-
Posted 9 years agoLadies and gents,
I have been trying fruitlessly to get the gears set up on my new 2013 Lapierre Spicy. I am running 1 x 10 via a 10 speed Sram long cage clutch mech and 10 speed X9 shifter.
I have two issues:
A) To stop the mech sitting on the cassette in the hardest gear I have to adjust the ‘B’ screw all the way in, which makes getting the wheel in a pain in the ass!
B) Both limit screws are on their extremes, the low end just to line it up with the first gear and the other all the way out. Even then I cannot get the easiest gear on setup. I could no problem on my old frame and its all the same kit. The shifter will click the right amount of shifts but the rear mech runs out of ‘travel’. Photos show it better:
The only conclusion I can come to is that the mech hanger sits too far out. Any ideas?
Posted 9 years agoThanks for all the replies gents, I have had another look at it this morning and more is arising! I have taken it all apart and put it back together but I am stumped.
The ‘B’ screw lug is definitely behind the mech hanger lug, I cannot mount it any other way (see photos below) And also I cant use the carbon protection wing that comes fitted to the frame as it interferes with the mech cage.
Mech hanger on its own, doesnt look bent or twisted.
Mech lug is sat on the mech hanger lug, cant see any other way!
As the sits in lowest gear with ‘B’ screw completely screwed in.
Carbon mech protector sits on the mech.
The topic ‘2013 Lapierre Spicy 10 speed gear issues…’ is closed to new replies.