cable routing is on the top yours is under top tube, so is the one im looking at earlier still??

Trekster
Andrew and I were meant to be doing it as a pair but i came a cropper at Kirry last week and managed to break my heel bone !! So no biking for a few months full stop.
Have fun

Will

Pegglet;
not mentioned a cast just a dressing so far. Will maybe ask for a removalbe splint type thing for the wedding though so it dont get knocked.

Thanks for the info i will look into running and using the kids wobble board.

How did you stay sane for weeks doing nothing? had a few days and i am getting a bored already!!!

ta

do you need the special rockshox tool for replacing the seals on a Pike or can you utilise a suitably sized socket?

lower leg oil change is easy enough but would like to do this bit too

Scottish Water are slowly picking up the pace with their next investment period so the key delivery partners may be resourcing up again

Farrans
Jacobs
Morrison Construction Ltd
George Leslie
Scottish Water Solutions 2/Veolia Water
and some of the other consultants

good luck

will

Ran mine (its got the DT shock) with the recommended sag and its ok but wasnt getting all the travel. I let a wee bit of air out and the brace across the seatstays clobbered the seat tube. Put another few psi back in and all was well-getting all travel etc.
I spoke to PACE about it and they obviously said it shouldnt if you run it right. They could fit a stopper in the shock if i liked to run it a bit softer than most.
Incidentlly the frame cracked at the welds (very fine hair line but there) on the shock brace after 9 months and the replaced the front end no problem.
Its got 6 months left on the 2 yr warranty so i am keeping an eye out for anymore and will be getting it replaced before the warranty runs out i fthey come back.
really like the bike as it lets me do everything on it (spain trips, xc races, Ae enduro, 24 hr etc)

cheers
will

Last time i sent my pikes (454 air) to TF they said they lubde the uturn assembly as i had mentioned a cli=unking noise at full extension.

Do i just let the air out and unscrew this bit to lube this up?

ta
will

cheers folks

mech look almost horziontal – have started to flick to granny (26t) and use 3rd 4th sprockets at the back which i never used to

not bust the drop out yet but had the front triangle replaced under warranty when cracks appeared on the shock brace welds – Pace sorted all no problem.

Had to face the rear disc mounts quite a bit too so it didnt rub

like the bike a lot

Where can u see the entry list? Paid up in the second wave and want to check I'm on there

Will be interesting that's for sure

Heading there for a long weekend at the end of May with a group of mates so these comments are very worrying – might enjoy myself too much – bring it on 🙂

Will

How long are you charging yours for?
had mine on for the 3 hrs as stated but dont think i am getting 3hrs discharge at high as they also say.

Light also just goes out when its done, cant get it to fire up in low or flash to get me home

will

waiting to see if i can get an entry – says its all full.

shame as i did it last year and it was great – only 10mins from the house too

Cheers will contact Olivia

It pissed it down on the sat last year then dried up great for the sunday. Was fast enough for me

just put a 2.2 TR4 Team Issue TLR on my bike and its very big. Seems to roll and grip good as well – hard to tell on the snow though need some mud again

yes i put it in?

make up your mind man !!

Get Steve to get both in for a test at Inners then decide

yep me and the missus will be there. Shes running i am riding. Not a race wippet by any means but i am sure some will be there

found this on pistonheads if you are in the scotland area

http://www.pistonheads.co.uk/sales/1397362.htm

might need a bit of work though by the sounds of it
Loads of Suzuki SJ's on there too.

An older Subaru Legacy woudl be a good bet, lots of room for bikes in estate version and pretty solid cars – had one on LPG for a few years

Will

big net might be good

Might be John, meant to be warmer on sunday – only minus 6 or so!!!

Whats Ae like at the moment? I havent been up to Mabie since New Years Day and it was crazy icy everywhere

Will

Hi john
Yes it's pretty dicey. Need it to thaw to try out my new winter boots from Santa 🙂

Mabie yesterday was hard going. Hard ice/ slush under snow sliding a lot. Meant to go to minus 5 tonight so will well icy tomorrow.

I have 410mm thomson now which I am only 20 mm above min line. So I reckon a 425 mm will be best bet.

Can anyone tell me the min insertion length on their dropper posts?

Spec defroster boots and merino socks. Well timed

Sorry meant riks at drumlanrig

hungry monkey – that was us just in front. We didnt realise until the last man went out how close it was. Our last man came back white as a sheet with your guy right behind him.

Top night out out 🙂

will

Badlywiredog
Do u just unscrew the aircan and grease the obvious?
What grease do u use?

Will

Good bike had mine 9 months, very different to my heckler!

A tad heavy but i run a large with Pike Airs Mavic 819s etc

Its actaully back for a warranty issue as the frame has cracked at the main pivot weld 🙁

Cheers
Let me know if you are selling as i am not in a mega rush

cheers again
will

Oh well just found out course in Carlisle isnt Part Time anymore as no interest.

When on clinical placement i assume you dont get paid an NHS wage?

Financial aspects of going back to Uni are pretty scary with kids,mortgage etc etc

I currently stay in Dumfries so in the right country perhaps just the wrong end!!

trail rat
is that the one at Carlisle?

will

yep went round our local – Mabie – and got very very wet. Good fun though

just checked mine and they have done the same same batch from CRC earlier in the year too.

Do you also get a clunking noise on compression ?

Will wait and see if leaving them upside down helps or if your moco service works? how much was the moco service kit?

will

my coil pikes never did it

they are U turn so i will check. Seems to make the noise across the travel range but is less when travel is less

will

Hi Treksetr (John) its Will here from Dumfries. I remember riding from Moffat to Samye Ling years agon when i did the 3 T’s with Eddie, Cyril etc was a good day out (70 mls!!)

Have riden some of the SUW into Wanlockhead too from Drum and remember carrying a bit. Will have a chat with the lads

cheers
will