So, I’m resurrecting this thread. The woes continue, this time on another rim.
On Saturday morning I was due to head out and discovered the new front tyre (Minion DHF) I’d fitted to my Flow S1 on the Reign was flat. I had fitted it a couple of weeks previous and done one ride on it. No problems at all before or during the ride. Anyway, start to pump it up and it’s not holding air. It’s pissing out through the valve. After a lot of swearing I took the tyre off. Valve looked fine, tape looked fine. But in my anger just ripped the tape of in prep for fitting new stuff and a new valve.
I’m not convinced at all. I’ve never fitted rim tape, and no doubt I’ll balls it up.
On the Nukeproof wheel I topped up the sealant. Made no difference. I’m also going to re-tape that one and potentially fit a new valve. But, I have an issue. My Flow S1 has an internal width of 29mm and the Nukeproof is 28mm. Stands recommends 30mm tape for the Flow. Will 30mm tape be okay for the Nukeproof too?
Although to be honest, I’m thinking of going back to tubes. I think tubeless is absolute garbage IMO.