yetihenry.

Put them into the Classifieds section mate. IF there brand spanking new you can get £80-£90 for the lot.

Hope that helps.

Well it was a pain to be honnest – wont be going near wheel milk again.

I like my Skin 8O

I was impressed with his whole speech – no reference cards etc all off the top of his head.

Better than the blubbering tit he replaced.

Ask Sram USA – explain the sitution. I have had Fisher UK Warranty stuff that was bought from America.

Ah i see.

Thank **** for that then.

Cheers

Hmm ok.

So how do they know what bank to send it to then ?

It would look terrible – gold sprokets on a red carrier ??

As far as im aware TiNi coating doesn’t harm the metal like anodizing does to steel etc – so why not just get the whole thing done at once ?

Not that i see the point – TiNi is a low friction coating. It’ll do bugger all in prevent the grit on your chain wearing away at the metal.

Mine 8)

500 grams with chainrings and Bottom bracket

Is it a specialized ? :lol:

Im running mine reversed – according to the front/rear arrows i am anyway… I’ve got the open end of the "U Blocks" facing foward front and rear.

Actually King headsets are well known, really well known for fcking your steerer tube. I certainly will not be buying one again, overpriced and over hyped.

Sad buggers.

Im ooop north near Edinburgh. Couple years back the Army decided to do a night battle practice or something – flares going off, blank rounds getting fired off. Was all a bit exciting tbh.

There’s a chopper up and about every couple of weeks messing around – they lift landrovers etc

There’s an old military base near me – the RAF use it for trainning sometimes, seen Herc’s landing there and helicopters reguarly trainning there too – so maybe there is something similar near you ?

What specialists you guys using ?

Well i did distroy a couple of things with the AT-AT walkers guns…

Just ask something on the spec normally shows these up…

OK.

Hopefully its just the colder then.

Thanks guys.

Ah…. That might be something ?

I took it outside from a warm house straight into the cold would that be making it sag more ?

I brought it back into the house and checked it straight away too…

Hmm Ok.

I shall take it for another ride after lunch to check what happens.

If i think about it i probably havent touched the air pressure in 12 + months as i got it late 07 about September, set it up and left it as is…

So fingers crossed it just needed a little re-freshing.

Valve core is tight.

Well i dont really know if it is exactly 50 PSI but i run it about 180 PSI and when i attached the pump it was down at around 145 PSI or something – i know you loose pressure when attaching and removing the pump hose but it must have been down on a bit of pressure as it was sagging about 60% instead of 30%

Davefarmer.. Where did you get that about the oil ? Sids have about the same volume of oil as Reba’s etc and such should be tweaked every 50 hours – just like a Reba,Pike etc

£500 for mine.

Im using:

DT 240 hubs
Some special light weight Stans 355 rims
DT Rev spokes
Alloy nipps

1404grams

Hmm thats the issue its all min order etc etc – cheapest ive found is £10 min charge so far.

Having been fixing this for the last week myself go out and give it a really long drive – 2 hour stint or something – fixed mine up a treat.

OK sounds like an option.

Thanks very much everyone.

Hmm ok. Its declared SORN at the momment too if that makes a difference ?

Dayinsure is for 23 + only like most places…. (Im 21)

Reason i dont want to get even a short insurance stint is that being under 25 and obviously a ragging mental head according to the insurance companies it’s not cheap to do so something that might fail.

Ah cool – didnt know that.

So if i were to get my father to drive it there who has fully comp insurance thus is insured on it would i be sorted ?

Well thats an option but i had to use one recently for something else and it was £50 for a quick 10 minute trip.

I had some wheels built by Stu of Penketh.

Not impressed at all with them.

I’ve found racing ralphs pritty decent actually as i ride on the roads too the trails. They cope with Ice well too as i found out last week.

Get some tubes with a removable valve core, put some Stans sealant in there – job done. Stans is a much better sealer.

Oop north myself – was sat with the back door open last week enjoying the brisk air, no heating on windows open at night too.

Bunch of pussy’s

Delivered me a parcel from California to the UK in 3 days by 8.00 am – no damage no fuss at customs either.

Farking good IMO.

If it helps get them from Germany – about £30 per tyre that way.

Tim youve got mail

Yeah i know a guy called Rob who lives in Balerno – rides the Pentlands too. Trying to remember his last name. Lives just up past the chippy in the big houses on the left side.

Paris is bad for that too….