Seams to be the best solution to a problem :-)

Cheers guys just what I wanted a list of bikes to have a look at. Yelli Screamy is jumping out at me though :D

:D

Well that is my main reason to find a new frame, as I like the HD that much but want a frame that can run them without to much clearance problems. I did fancy the Kinesis FF29 but it will only take a 2.2 :(

The Buzzard looks nice but bit to long of a wait. And didnt really want Fat, more a standard frame

enjoyed them thanks

Just gone to HD pacestar on the rear and trail on the front on both bikes. Cant rate them high enough

Put some glitter in with the fluid, help seal bigger holes quicker

Done

They couldn’t honor my order for two calipers. So I canceled my order :( And if you already have the M985’s just drop the new calipers on and bleed ?

That’s no moon

:-)

And dont put down insulation and then compress it when you put the boards over. Lift the boarded section and then insulate :-)

Its worst of the top of my foot, been to the docs about a month ago and had confirmed it was tendonitis.

Ive messed around with saddle and cleat positions and it always come back to the same result. Not knowing what your doing im sure is the main cause. Thanks guys I think ill look into a bike fit and get it sorted.

Stans have served me well.

Ive owned both and the smaller was the better ride. just a tad more fun :D

Get your self an EPC and see what is available for you through the Greendeal

thanks :-)

^^ Ah they dont make pills like that any more :-)

Some good stuff over on Mixcloud

Just got some Hans Dampf’s and been very impressed with them in the wet

Run a water coil in the flue, that runs to 1/2 radiators on the second floor. Try and reuse heat recovery from the flue

Map to be found here,

http://www.roughrideguide.co.uk/mtbike/2010/07/chilterns-challenge-woodcote-nr-reading-berksoxon/

Epic day for me, just ticked every button. Big well done to the organizers :-)

I was only there as pit crew, but it did seam like a good event. And will be looking to ride it next year. Every one looked they they enjoyed themselves :-)

I cant get these tyres to seat on crest rims

^^ +1

I just wanna say thanks to the two girls who were Marshall’s at the top of the muddy wood trail. Who were the most cheery happy people from the whole event. It was a real pleasure to see you throwing so much into it in those conditions. I know a lot of riders who would like to thank you :-)

Guys can some one link me to a few mods usernames ? I have a few ideas to pass over.

Thanks Rob :-)

Two stone down in 8 weeks, not been sticking to it massively at weekends. Which has help me get through it.

And mine, mucho thankyog

Great idea, YHM

Bought one of these a few years back, and ive not had it since. I do get the tickles in my nose every now and then. But just take it every morning and its seams to have cured it as best it can. Cant recommend it enough

I have a set on my SS and they are great for the money

Total gutted about mine, some 40 seeds went in about 8 weeks ago. and not one has germinated this year :cry: And you will need to separate them all off into there own pots if you want the best results.

Once you have an account you need to pay the deposit into it. This will create it id for the tenant

Check all your basic insulation and low energy lights. No point in seeing it on a meter if its going out the walls :wink:

I can recommend a anodizing company, the set up cost is £25 plus £6/7 a part I think.

http://custompb.co.uk/#/anodising-and-lasering/4558856291

Ive been on the On Ones 29er wheels for a year now and cant fault them. Still on the original bearings with no play to speak of yet. Very happy with them for the money