Hmm, haven't actually listened that carefully and i imagine it'll be quite hard, it's only when there's a hard impact or on really bump stuff, not when i'm just bouncing on them riding on the road

Yeah, sounds like some kind of rattle in the damping if that's possible?

nope

Forgot to mention these are the 409 dual air model

Just out of interest, is the damper on air and coil pikes the same? Don't flame me if i'm sounding like an idiot!

Ok i'll have to leave it then i'm afraid, I need a bit more than that!

Rob – what do you get in the set, and are they used or new?
Grumm – can't see anything wrong with it to be honest, hopefully someone can confirm if this is ok

So all i need is a couple of crush washers which probably cost all of about 2p to make, but I have to buy a full £25 service kit?

I'll probably end up taking them actually, just need to check a couple of things first! Any idea where to get the crush washers from?

Brilliant, thanks for all the info! Does any oil need to be replaced after doing that small service? And will i most likely need to just reposition the seal like you did or will i have to buy a new one? Also I couldnt quite make out which seal you meant was the problemed one in your forks, where abouts is it?

I'll give TFTuned a ring but i'm pretty sure its neither of the last two as TFTuned have actually serviced them recently. The guy i bought them off lowered the travel for me so something must've gone a bit wrong there

Thanks, so how is the best way to seat it? And does anyone have an answer to 1?

2nd hand, any idea about the others?

Well they are locked up at night but after letting them out this morning they wandered down into our field and a lot of quacking later we were minus a duck, i even saw the fox running off with it

Llamas may be the answer, i've always fancied them! Failing that, how long will a 'scent mark' stay around and how spread out can they be?

Trouble is we have quite a large garden meaning we can't really keep an eye on them the whole time.. And i'm not sure i have a large enough bladder to cover the whole garden

Forgot to mention, i've cleaned and sanded the pads and rotor in every way possible which as i said works at first but overnight they seem to get contaminated. I can't see why it would go spongey like this unless it had lost fluid which brought me to my conclusion, seems like i do have a leak then but what can i do about it?

I had this as well, just give the dropouts and washers a good cleaning to get off any grease, and I got some hex head bolts so I can tighten them up more. All sorted now!

bad luck, have a look on trade it and gumtree etc though, chances are they’ll be selling them on through some website