just to let you all know we have found kye!!! :) he was found a mile away from home stuck down a hole that looks to be part of an old building burried into the ground, he had fallen down it and couldent climb back out! kira found him but hes safe and sound at home now :)

no she dosent have a van, its normally me who walks them usually, if shes walking them we usually together lol, guna go for a ride today and have a look around the tops

cheers guys, keep eyes peeled!

hmm, ok cheers guys

not sure all i know its got 4 pads in lol

ah clicking it works lol

ive just managed to blag a friend to sell me two tires for UST Schwalbe Hansdampf for £60 for both, rekon thats a good deal? as said above if im going tubeless go all out with tubeless tires so its all good what u rekon!

Trambler was you ok with thw single ply minions then beacuse ive just rang my lbs, and they say its a gamble if they would work or not, because the single ply minions arnt a ust tyre but i can try it… either that or its 2 new tyres for tubeless setup :/ not really sure on what to do tbh or the best way to go about it

alright guys thanks for the advice cheers

yes but its all guessing, id rather be shown or told so i know im doing the right thing lol

thats what im already doing, im sorta taking off on the left so i get fired over to the right the back end swings out to the right and straighten up but its nothing like the whips i see :/

what are the Nano ?? what do you rate to these http://www.chainreactioncycles.com/nukeproof-electron-flat-pedals-2014/rp-prod85858

could of been a bad batch though? keep em coming peeps!

i suppose, i was thinking theft wise too lol, ill take it off then and just leave the cross bars on incase

alright thanks peeps no i dont have any yet, just found that 9 speed normal 32t chainring, ill get a narrowwide then thanks

ive an alpine 160 and thats a 1 x 10 setup with a blackspire normal chainring 34t and that aint narowwide, and thats got an e thirteen chain device on and had no problems so i guess it will be fine

yea it was upsidown when i pushed pistons back in, but ive done that over the years and not had this prob before, ill get em bled thanks :)

what are the bikes they use up heywood jump park? there like bmx but big bigger

I dont have any orange washers , u mean the orange stopper ring that tells u ur limit? My cranks just came as cranks nothing else

yeh thats all i do, i just hold the drive side arm and turn it until it lock onto the thread, it gets half way before it becomes tight, after this its just really right until the end, is this normal then ?

do they work the same way as the atlas allmountain? the single 8mm bolt holding em on? i can get it to fit but its really super tight it just dosent feel right, theres no play once on and spins freeley it juast worries me how tight on they are :/

right cheers guys

what ive done is wrapped some paper around it and measured it in mm and divided by pi, which is what i got told to do, it comes to 35… i guess thats a 34.9 so u could be right what u rekon

i guess the 31.6 is smaller than the 31.8 though…. hmm how do i found out what my frame needs is there a way?

anyways went into the shop today with my pc, they tested the card in my pc so i could show them the errors, they saw the errors and couldent really understand it, they then tested a factory card they use on all pcs just to make sure its the card and nothing else their card worked.. so it must of been a conflict with the card somewherre, anyway after 4 hours they gave me a full refund for the card as it wasent my fault as it was compatability issue and i swapped it for the same card but MSI not asus, took this card home got latest drivers pc working fine :) lol

the connecters are exactly the same on both psu`s and my card has 2 pci-e connecters to the grx card and ive only 1 hdd :)

Another question as well, i bought a corsair cx600w psu with the card as they told me my standard psu 850w wasent good enough to run the card? its just a standard no name psu, i think its called power switching or something nothing special, when i put this new one in at 600w they sold me i notice windows takes longer to load on start up, but with the old one things do seem alot quicker, any reasons? im told Wattage wont speed things up but i notice the old one is defo quicker at loading windows and starting programs up etc?

yeh ive tried another slot and no joy, ive just rang the store now and told them im bringing my pc in tomorrow so lets just wait and see from there , they said it could be something or nothing maby something uve not done or something simple, yeh right ive tried everything lol so taking it in tomorrow and ill let u all know how i get on ! thx for the replies!

yes i went into the shop and bought it, i got home, put it in, installed the drivers, and problems.. i tried more drivers, tried another screen another cable and still nothing.. i took it back to the shop and they told me nothings wrong with the card as they tested it to the max apparently.. they said be cafefull its hot.. lol got home and still no joy.. ive just used guru 3d and another driver and still no joy :(:( they told me i would get charged a restock fee for bringing back items that are not faulty..

my last card was radeon 5800 1 gig pci-e this works fine as ive put this one back in now, im going to the shop on the weekend and telling em what the crack is, this will be my 3rd time now going :/ they said for refunds they want a 25% restocking fee :O cheeky! just wish i could fix the issue tbh, ill try omegadrivers though.. keep em coming guys thanks.

yeh i removed the previous drivers before installing the new ones, i bought a new psu with it too and ive even tried my old one and still nothing :/

ive tried my girlfriends screen and it does it on there too, tried her cable too and same problem :s

Blue pig in hard castle crags

Sorry guys, me again, thx for the advice so far! – i went to my LBS and he told me to get a E thirteen LS1+ it looks ok… any one got one of these? it will be used with my zee clutch mech if i get one thanks :)

ill keep that in mind too cloudnine thx

reggie send me a pic chris_mbuk@hotmail.com i may be interested :)

its a kmc gold 10 speed chain with a blackspire 34t chainring, it came off twice since ive made it 1 x 10 so i just wondered what the options are, its an alpine frame 2011

hmm i want a zee cause ive been hearing alot of good reviews, i dont like to mess around trying things… so ill prob just go for the 1 x 10 and get rid of my granny ring, and go 10 speed by 34t up front which is what i have so ill prob just do that instead :)

yea im thinking maby a 10 speed shimano casette, zee shifter, even though it says 1×10 shifter? but im sure that dosent matter if ur running a 22 and 34 ring up front as its a rear shifter lol and maby a nice kmc gold chain 10 speed! sound good?

nop not guna budge, im guna take the **** into work tomz :/