Cheers jim600 I’ve used 2R3QNSCU

worked fine

All of them, except YouView

I’ve never had any problems with them

33 posts 20 voices
Or are there…

Warm it with hair drier / heat gun

or boiling water

Merlin [/url] http://www.merlincycles.com
never let me down yet

…and the answer is it could be 122.5
who’d of thought
Oh and the left crank is fcuked from being ridden whilst it was loose

Thanks all I’ve gone 113, it’s only 1.5mm either side, what could possibley go wrong…

Thanks clubber

The key question is what chainset is it – that determines the axle length needed

it’s a Shimano Hyperglide triple
I’m thinking risk a 113 or get both and send one back

Suunto

In such a situation, one will certainly lose either the loan or the friendship, and quite possibly both

On the money Markie

I’m loving the look of the tentacles you’ve fashioned already, the end result will look unique and stunning and I’m really quite envious!!

Here, here, wish I had a ‘proper’ job still. I really miss the thrill of turning something 2D into a 3D object for the first time. It’s is immensely satisfying
Thanks again to you all for such an intriguing thread

I’m not so keen on the half lap joint. I’m sure it will support the weight, but it wont prevent the parts separating as well as a mortise & tenon. Needs must I suppose.
In my ignorance I have used pieces of brush handle to make dowels before. They are seasoned, the right size, have a long straight grain and are readily available. I didn’t have any oak either.

Yep, Suzi Perry…

Opps sorry first line was from a different thread. Doh

Looks amazing, not often envious but the weather…
What an amazing thread
I can’t offer anything to what’s been said, after all I’m only a Pattern Maker. Would love to see some pictures of the finished item
Once more what great community spirit you’ve all shown

Windoze 8 think of the ‘Metro’ Tiles as a big ‘Start Button’
Anyone remember Millennium?
This is similar in that it is a look at what future releases will look like imho
I quite like it though…

44.3 mph dropping down into Dunford Bridge on Trans Pennine Trail

Definatey be asking for a black one if it was me

I think that’s about half price, but if you’re happy him will be and that is what makes the world go round.
Going to be very tight for the washer, glad I haven’t planned. It’s bespoke make a bit more room ffs

IMHO if you’re going to strip the hub down it’s best to change all the bearings.
Stainless or steel? Stainless won’t rust but they are softer so don’t last as long. I’d go with plain they’re sealed and greased I think they are the best compromise
http://www.simplybearings.co.uk