Forum menu
I've been building up a new slot dropout Scandal 29er - and have tried two different front mechs, but neither fit very well.
The fisrt was a conventional front mech, which would work cos the bottle bosses were in the way.
The 2nd is a compact type deore (M530 I think), which fouls on the tyre in a big way.
I'd prefer to run the rear wheel as forward as possible, any suggestions for a mech that fits quite well?
Cheers
what tyre?
dont have much to add as i haven't done this to mine yet...
could you move the wheel in the dropouts to get some clearence?
used a XT conventional on mine fine... but that wasn't the SD model
riding buddy runs a top swing on his - i'd post a picture of it but fotopic is having issues....
SRAM here, albeit on the geared version; as posted frequently a couple of years back, it helps to cut off any unnecessary bits.
I recall filing a bit off the clamp to fit around a bottle boss too.
[img] 
[/img]
P.S. that's a 2.3" tyre
go here:
http://picasaweb.google.co.uk/northmalvern/ScandalFrontMechAlteration#
this is my photo log of modding a dual pull conventional mech for clearance.
Cheers for the help guys. In the end I managd a very neat bodge to hold the axle back - I'll maybe get a photo one day.
Essentially it's an m6 nut at the front of the slot dropout, held in place by a zip tie. One each side makes putting the wheel back in a doddle!