[Closed] Rear shock sizing.

You may run into problems at full travel, tyres touching seat-tube, linkages fouling etc. I'd try drilling a piece of wood(or similar) to take your shock bolts at 216mm-57mm to simulate full travel, then check very carefully for likely contact points.They aren't cheap, so it's an expensive mistake for want of 10 mins in the workshop if it doesn't work.

bike is 216 x 54

Mine was a few mm less than the stated shock size when I measured it

i thought if eye to eye was the same you'd probably be ok...

Depends basically on how tightly designed the bike is- with my Hemlock frinstance it's all very well packaged so there's really not much space to muck about. But if it's got some spare clearance there's a good chance it'll be fine

even though the eye to eye is the same the longer stroke will give it more travel if I'm correct? but to work out how much more travel you would need to know the leverage numbers etc that how I understand it anyway

Thanks all, I have 6mm of clearance at full travel on the current shock with all the air taken out. Seems to be a choice of either risk it or not.

TFTuned will custom make you one the right length if you require , Ring & speak to Dave.

What bike is the shock fitted to out of interest?

Spesh enduro 2011 model. Does say no fit on cane creek website also.