Forum menu

[Closed] QR vs allen/hex bolt skewer tension...

TuckerUK · 2011-06-21T23:10:08Z

I've searched (here and elsewhere) and read a fair few topics on this, including many ending up with allen/hex key skewers snapping, but I've found none that address correct tension (i.e. how you know when a allen/hex skewer is tight enough) using the obvious cup & cone bearing play removal method. So, with cup & cone hubs correctly adjusted to give some freeplay with a loose QR that tightening the QR removes, how easy is it to remove that same play using a allen/hex skewer?

Page 2 / 2 Prev

TuckerUK

Posts: 0

Free Member

Topic starter

OK, as promised and with thanks to my generous benefactor Junkyard.

Hmm, don't seem able to insert video, so I'll link to them instead:

[url=

Part 1 of 2[/url]

[url=

Part 2 of 2[/url]

Posted : 04/07/2011 11:52 am

Page 2 / 2 Prev