Forum menu
Topic starter
I have a Hope Pro 2 rear hub (converted to Evo spec some time ago) which I have been running XX1/XD with 12mm axle using the appropriate XD-specific end cap. All is fine..
I've just tried to switch the end caps to QR and when I tighten down the cassette it appears to bottom out on the D/S end cap, stopping it from spinning. I have tried both with and without the 2mm spacer but it makes no difference.
Any ideas? I can't see an XD-specific end cap for QR like there is for 12mm..?
Posted : 27/09/2015 2:20 pm
Posted : 27/09/2015 2:37 pm
Topic starter
Cheers!
Posted : 27/09/2015 3:02 pm