UPDATE: Reviews section refreshed, redesigned, searchable: Go take a look
Can this be used with Hollowtech 2 bottom bracket? It doesn't look as if there is room in a "standard" BB shell.
Tom
Tom, the Carver EBB is compatible with any english thread BB available, so yes, a HT2 works fine.
Thanks Trev, I assume there is limited adjustment but enough to take up the slack.
Tom
are you running it at the correct torque? 75-80 inch pounds or you could over tighten, and then you will be stuck............
Sounds like Tom is thinking of trying to fit a Carver EBB into a standard BB shell?
If so it won't fit.
It will fit in most EBB shells and take a HT2 crank though.
😳 SSstu, you are correct and I have now learned the error of my ways. Thanks guys, most helpful and my apologies!
Tom
