Works Components Fitting Instructions

  • This topic has 1 reply, 1 voice, and was last updated 5 years ago by  Tim.
Viewing 2 posts - 1 through 2 (of 2 total)
  • Works Components Fitting Instructions
  • Tim
    Member

    Hi all

    Picked up one of these a while ago:

    http://www.workscomponents.co.uk/15-degree-zs49—zs49—traditional-15-reducer-headset-52-p.asp

    Just came to fit it, bike in bits and I cant find the fitting instructions.

    I’ve emailed WC but wanted to try and get it done today if poss 🙂

    The bottom cup is fairly obvious. Fat edge to the back.

    The top cup is less obvious – its got two lines and a little nick out of one of them. Does this go front or back?

    I’m going to mark the headtube to show dead centre at the front top and bottom which should make life easier.

    Headtube has been cleaned and lightly greased – cups are nestling with the frozen peas

    Cheers!

    Tim

    Tim
    Member

    Turns out they fit quite easily as they sent 44mm cups, not 49mm 1.5″ cups 🙄

Viewing 2 posts - 1 through 2 (of 2 total)

The topic ‘Works Components Fitting Instructions’ is closed to new replies.