Viewing 11 posts - 1 through 11 (of 11 total)
  • Windscreen washer pump leaking, any tips?
  • Premier Icon ed34
    Free Member

    My washer pump packed in so had to replace it, but now it’s dripping where the pump goes into the bottle. Pump just has a grommet over the inlet and that all pushes into the washer bottle.

    I’ve tried with the new grommet and the old grommet but still drips!

    Anyone got any advice on how to fix, might try lots of PTFE tape next to try and make the inlet on the pump a bit fatter so it squashes the grommet thing more.

    Premier Icon trail_rat
    Free Member

    epoxy ?

    Premier Icon johndoh
    Free Member

    PTFE might be worth a try (as you suggest) or a decent think elastic band?

    Premier Icon bikebouy
    Free Member

    PTFE, and maybe the small rubber gromit has been pinched and buckled a bit.

    Premier Icon phil5556
    Full Member

    Is it a genuine pump & grommet? If not there’s a good chance a genuine one won’t leak.

    Premier Icon finishthat
    Full Member

    smear/splodge of silicone sealant after a good clean

    Premier Icon spennyy
    Full Member

    Boss white will sort it, just don’t drink out of it after.

    Premier Icon ed34
    Free Member

    Thanks I’ll try PTFE and boss white as got some of that somewhere. If that fails ill get a genuine pump and grommet!

    Premier Icon 100inch
    Free Member

    Premier Icon sharkbait
    Free Member

    Self-amalgamating tape might be better than PTFE…. More thickness

    Premier Icon subduedsupernova
    Free Member

    Put the grommet in the washer bottle first then put the pump in the grommet

    And as said earlier is pump and grommet genuine? If universal/after market might need to bodge it

Viewing 11 posts - 1 through 11 (of 11 total)

You must be logged in to reply to this topic.