Ultegra RX set-up - Singletrack World Magazine December 8, 2019

Overview Chat Bike Members News Women

This topic has 4 replies, 3 voices, and was last updated 4 years ago by john_l.

Viewing 5 posts - 1 through 5 (of 5 total)

Ultegra RX set-up
john_l
Free Member

Possibly stupid question regarding RX Ultegra mech fitting. There are 2 plates on the rear, rather than the usual 1 that rest on the hanger stop.
Which one should you use – top or bottom? Makes quite a difference to the angle at which the cable enters the barrel adjuster.

Posted 4 years ago

john_l
Free Member

Have figured it out.

Posted 4 years ago

13thfloormonk
Full Member

What was the answer? I installed it with both plates above/behind the tab on the hanger, but haven’t gone any further

Posted 4 years ago

FGF 701 The Hydrate Or Die Edition

scotroutes
Full Member

https://si.shimano.com/#/en/iDM/GARD001/installation/toc_xd_42bdf4421e6322e8-3cc6b207-166e81b15e9–7dac

Posted 4 years ago

john_l
Free Member

Yeah, that.

Makes for very tight cable routing but seems to shift ok.

Posted 4 years ago

Viewing 5 posts - 1 through 5 (of 5 total)

The topic ‘Ultegra RX set-up’ is closed to new replies.

Overview Chat Bike Members News Women