Hi all

Anyone know the sizes/specs of the O-Rings for these forks and a source?

I have a set that are out of action and all seems good except the O-Rings on the air piston are baggier than a baggy thing and they seem to lose air pressure very quickly and not recover their ride height.

I’ve messaged Spinner via FB but so far not got a clear answer wondered if anyone here had found an e-bay or similar source (or a service kit) and managed to stop the things leaking air?

Also anywhere else obvious I could be losing air from?

I’d measure them myself but don’t have a set of verniers (note to self must order some)

Thanks

There a European service center address at the bottom of this page – maybe worth an email/call?

https://www.spinner-usa.com/contactus.htm

Not sure which FB page you found, but the page for the European distributor in Poland has quite a bit of info in it and looks to be pretty responsive:

https://www.facebook.com/SPINNER-SUSPENSION-FORKS-307348999289102

There’s some service info here, with a comment “Used o-ring at air piston caused air leaking.”

Posted by SPINNER SUSPENSION FORKS on Wednesday, January 23, 2019

Thanks both. Had a message back from the folks in Poland very helpful and it seems there are two possible seals so time to take apart again and check which.