Afternoon, All.

My Reverb is showing strange behaviour. Some days it works, other days not at all. Yet other days it works, but very slowly. I’ve bled it twice following the correct procedure, but to no avail.

Any thoughts? I’m wondering if the remote is at fault.

All the best and keep safe,

Dom

Topped up the air as well? I like to keep mine at or close to the 250psi…

Are you setting the speed adjuster to ‘slow’ for bleeding, then setting it back to ‘fast’ again afterwards?

Yes, air topped up and speed adjuster protocol followed. It’s a mystery!

Just rebled the dropper and it’s working well. In fact, it thinks it’s an ejector seat now. On full slow, it’s faster than it ever was on the highest speed. Fingers crossed it behaves itself, but it is a Reverb, after all…

Thanks for your suggestions.