• This topic has 5 replies, 3 voices, and was last updated 5 years ago by jsm.
Viewing 6 posts - 1 through 6 (of 6 total)
  • canyon spectral gear cabling
  • Premier Icon jsm
    Full Member

    Anyone changed the gear cable setup on their spectral? It’s two part with just the wire inside the frame, no cable outer.

    Anyone swapped it to be fully outer cabled?

    https://www.dropbox.com/sc/wnge9qxlhll376a/AAAS_3pKLvQTQe20jj15VcZVa

    Premier Icon james239
    Free Member

    If you’re changing cable, pull a piece of string through with the old cable then usr the string to pull the new cable back through.

    No need to put outer all the way through, and no faff threading the new inner through the frame.

    Premier Icon jsm
    Full Member

    Cheers. I meant has anyone swapped from having two outer sections and a middle with just the cable, to a fully outer gear cabled setup on the spectral.

    Premier Icon jsm
    Full Member

    anyone looked into this?

    Premier Icon nealy
    Free Member

    There’s quite a bit of friction in my gear cable in the length through the chain stay so considering running that length external to avoid the sharp bends and may do full outer with triple cable clamps on the downtube although you could drill out the hole in the downtube and run the outer through it.

    Premier Icon jsm
    Full Member

    @nealy did you do it in the end?

Viewing 6 posts - 1 through 6 (of 6 total)

The topic ‘canyon spectral gear cabling’ is closed to new replies.