Viewing 8 posts - 1 through 8 (of 8 total)
  • Boostvalve RP23 – cant remove air sleave?
  • hora
    Free Member

    To fit a thicker compression ring. I’ve done this before with ease ona different RP23. This airsleave just spins though both ways with no tightening/untightening apparent. You can actuate (?)it slightly by 1mm (top of sleave to housing but it wont unscrew.

    Ideas?

    (It holds air etc)

    LoCo
    Free Member

    Xv air can? Hold the bottom of air can ( by wiper seal) to turn it 😉

    scaredypants
    Full Member

    STEP

    AWAY

    !!

    Fresh Goods Friday 696: The Middling Edition

    Fresh Goods Friday 696: The Middlin...
    Latest Singletrack Videos
    hora
    Free Member
    walla24
    Free Member

    loco +1

    big_scot_nanny
    Full Member

    Whoa, hold on, I think that is a higher volume can, there is a circlip thing you need to take off first.

    http://singletrackworld.com/forum/topic/fox-rp23-boost-valve-high-volume-air-can-problem-help

    hora
    Free Member

    Ah!

    LoCo
    Free Member

    No you don’t need to remove the circlip unless you’re replacing the seal for the xv sleeve 😉 if the can is too tight you can use a rubber strap wrench, make sure you’ve let the air out too 😉

Viewing 8 posts - 1 through 8 (of 8 total)

The topic ‘Boostvalve RP23 – cant remove air sleave?’ is closed to new replies.