Viewing 8 posts - 1 through 8 (of 8 total)
  • 2011 Blue Pig reach measurement
  • citizeninsane
    Free Member

    Anyone know the reach measurement of an 18″, 2011 Blue Pig? I found some numbers over on MTBR (407mm), but not sure if they pertain to the 2011 or the previous incarnation.

    davewalsh
    Free Member

    Don’t know the reach but the ETT was 597mm if that’s any good to you.

    citizeninsane
    Free Member

    Yeah, got the spec sheet that has that on it. No reach (or stack) there unfortunately.

    Fresh Goods Friday 696: The Middling Edition

    Fresh Goods Friday 696: The Middlin...
    Latest Singletrack Videos
    bennn
    Free Member

    Is that frame the same as a Mk1? If so I can go get a measurement if you tell me where to measure from, and to.

    Ben.

    citizeninsane
    Free Member

    I think the geometry is the same as the mk1, but not sure. I have the bike and have tried measuring it myself, but the measurement is a good 20mm out from what I’d expect it to be, so I must be doing it wrong. Hence why looking for the official figure. Might take the wheels off and try it again. Apparently, for every 1 degree your floor is off level when measuring, that affects the measurement by about 1cm.

    Just foung this Measuring reach, so gonna give that a try.

    Waiting on a reply from Ragley, but that could take a while.

    bennn
    Free Member

    Haha ok!

    citizeninsane
    Free Member

    Just so you know, I’m trying to compare it to another frame, so I know if it will feel similar, or not…

    davewalsh
    Free Member

    And the other frame is ????

Viewing 8 posts - 1 through 8 (of 8 total)

The topic ‘2011 Blue Pig reach measurement’ is closed to new replies.