I’ve done some serious swearing this evening. Front rotor has taken a knock and was slightly bent, I’ve tried straightening and it was actually almost perfect, but it annoyed me so I decided to go for a swap for some decently priced RT86 rotors. Back one swapped Ok, seems a bit more snug but then it’s a new rotor.

Front rotor is proving really difficult to get in without it rubbing the calliper on one side. It’s in the brak Big area, not the inner section or bolts. Can anyone offer any suggestions; I’m thinking about taking out the little tightening plates which should shift the rotor a few microns?

Bike is a cube attain GTC.
Is this a combo that should be OK?

Thanks in advance.