Ordered some bushes yersterday for my rattly ’01 SID rear shock. I can’t find a proper tool for 10mm bushes anywhere. How easy is it to do with sockets/vice etc? I have done 2 bikes worth of pivot bearings like this with no trouble but cartridge bearing outer races have a bit more width to push on.

Any tips?

is my tool not suitable then, will do rs and fox bushes

[double entendre] your tool is too wide for my requirements [/double entendre]

yours is 12mm and i would need a 10mm one according to the nice man on the phone at TFtuned.

Bleddy spindly xc lightweight nonsense…