I am rebuilding an old pair of Junior Ts (2003) for a wee project and am a wee bit confused as to how he oil levels are measured. I know the measurements etc just need to know how to measure them. Do I remove the top caps and the springs then push the stantions down into lowers, fill and then measure from top of stantion to oil level? Think this is right according to what I have read but just need some confirmation?

Yes you are correct 🙂

I know this is for the 01 version – but the principle has always been the same.

http://www.enduroforkseals.com/sitebuildercontent/sitebuilderfiles/jrt_01.pdf

Thanks. That is all I needed to know 😀

Just added a link to the 01 manual (my old link to all the manuals from 00 to 07 has died now 🙁 ) in my original reply !

Don’t forget to pump them a bit so the oil fills the damper before measuring 😉