I need to bleed my recently fitted Tech 3 E4’s and I’m sure I read somewhere that the reach and bite point screws should be in certain positions.

Unfortunately I can find the post, I assume the reach should be all the in and the bite all the way out?

Also any tips for getting the the master cylinder flat when bleeding.

There are videos on the Hope website which show you how to bleed them.

HTH’s.

Thanks I’ve watched the one where he bleeds the Tech 2(?) lever, which I think us the newest video but it makes no mention of the adjusters. Maybe I dreamt reading it!

If it’s like the tech, bpc all the way out to maximise the master cylinder volume and reach adjust all the way in to maximise the stroke.

Then readjust to preference once bled.

Thanks teethgrinder, that’s what I meant in my OP but didn’t describe it very well. See how I get on later.