ok I know its a dum question but dose anybody know how to remove a lefty hub end cap I need to change my front wheel bearings. And I need to strip my rear code hub bearings seem tight and would it be possible to change it from a standerd qr to something stiffer

You need a pin spanner.

Think the front hub cap is a left hand thread (turn clockwise to unscrew)

Bolt

You’re welcome to borrow my pin spanner if you are near Bath or Cardiff, otherwise they are quite cheap on Wiggle etc

Thanks all iv made a spanner so bearings out how just the back wheel to look at

I need to strip my rear code hub bearings seem tight and would it be possible to change it from a standard qr to something stiffer

Code or Coda? I doubt you’ll be updating the axle on a coda hub….