right so after the failure of my trailtech (rush) HID, i purchased the bits i needed for an LED conversion…

LEDs
Optic
Driver
New switch

So all that i am now missing is a heatsink. Bought some ally bar from ebay and was intending to get it turned down by a mate who has his own machine shop. However, he is just too busy with paying work to do it so need an alternative…

What can i use???

What can i use???

coarse wet and dry and some elbow grease?

needs to be metal. imo.

you might get away with a metal loaded epoxy/ ceramic type thing but you might be getting into v. specialist areas and they’ll end up costing loads.

coarse wet and dry and some elbow grease?

believe me it had crossed my mind! but i need to take 12mm off, so i reckon it’d be after the clocks go forward by the time i’d finished..

surely you can just by a slightly smaller diameter bit of ali?

but i need to take 12mm off

saw, then sand.

hacksaw then use a Bastard File?

Isn’t the trailtech a plastic case? Fairly sure mine was.

I’d suggest a big one in that case 🙂