Wondered if the collective wisdom of single track can answer a nagging thought in my mind. I have two pairs of revs. A 2009 140mm pair based on the pike fork and a 2010 150mm QR pair with the power bulges. The though I have is can I swap the lowers over to create a 150mm 20mm thru axle pike based Frankenstein fork.

Anyone done this or have any views?

Anyone?

Email loco or tf tuned would be my first port of call.

Just do it. It’s only a 15min job so not hard to reverse. It’ll probably work I reckon, as long as you keep the travel at what the lowers were designed for (spacer in the air cartridge) I think you’ll be fine. 🙂

assuming the stanchions are the same width yes I think so. but as said above you may need to reduce the travel. I think you might need the bushings resized too but it should work.