Being a bit ‘aiming for perfection here’, I acknowledge, but I’m after a 7mm headset/stem spacer, and can’t find one anywhere!!!
Crc, eBay, etc etc

Does anyone know which direction to point my money at at all??

Ta!

DrP

(In a typical stw fashion, awaits this thread to contain comments telling me “not to look for what I’m looking for”, alternatively the thread being closed after a heated discussion about racism and the rights and wrongs of child pornography!!!) 😉

Here

And here

Never seen one. But 5mm and 2mm are available…

I’ve never seen one, you may have to cut down a 10mm instead, carbon ones with a fine hacksaw blade cut neatly..
You Racist Nazi Pervy bastard….. 😀

I found bmx ones, but bmx = 1 inch, no?

DrP

<sigh> you never stated 1 1/8″ or 1.5″ 🙄

Typical unclear post by STW poster who asks for help but doesn’t give the full information reqiuired. 😉

Does anyone know which direction to point my money at at all??

A 10mm one, then a trip to a hobby shop or a small engineering place to have it whittled down on a lathe?

Chris King do 6mm ones?

High On Bikes have this lot on eBay that includes a 7mm, but if you really really really only want the 7mm just give em a call and ask nicely.

Cheers thepurist, have contacted them about individual spacers!

Filing that, I’ll just have to clamp the stem down using a 5mm spacer on top, then remove it when he stem is tight.

DrP

No one has asked…why?

A customer in my last lbs job wanted 1mm spacers so he could get his TT stem position “just right”. Yup, he was and is a **** 😀

A customer in my last lbs job wanted 1mm spacers so he could get his TT stem position “just right”.

Worked in a ski hire shop once, had a customer bring skis back “because they wouldn’t run parallell”.

1mm is hardly “perfect” I use two 0.2mm spacers and no top/dust cap under the top crown on my DH bike to achieve near perfect clearance to run the fork as raked out as possible without resorting to a drop crown (which would cause all sorts of other “issues”)
My bar height is always adjusted to within +-1mm, why wouldn’t you?

My bar height is always adjusted to within +-1mm, why wouldn’t you?

because the grips and palms of my gloves probably have more than 1mm ‘give’ between them.

because the grips and palms of my gloves probably have more than 1mm ‘give’ between them.

Tsk. You need some better gloves.

Middleburn do all sorts.

Waswas – you’ve clearly never seen my “grips” or “gloves” 😆

Don’t want any spaces above the stem, and essentially the steerer needs another 2mm off it, which I’m not going to achieve…..
Don’t want to run a 10mm spacer below as that will be a few mm too little steerer clamped in the stem……

DrP

That may look tidier but ahead stems clamp your steerer more securely with a spacer above.