Overview Chat Bike Members News Women
Viewing 8 posts - 1 through 8 (of 8 total)
  • Converting my hope hub to 10mm qr.
  • zippykona
    Full Member

    A quick you tube search was fruitless.
    I’ve got a superstar 10mm we and 2 new hope end caps.
    Do I need anything else and how do I do it?

    Posted 10 years ago
    Onzadog
    Free Member

    Which hope hub?

    Should just be a case of remove old end caps, fit new ones. Fit 10mm skewer, put wheel in frame.

    Posted 10 years ago
    mudmonster
    Free Member

    Just pull of the q/r end caps and push on the 10mm caps.

    Posted 10 years ago
    ThePinkster
    Full Member

    Just pull of the q/r end caps and push on the 10mm caps.

    ^^This.^^

    Did it to my Pro3 SP rear a few months ago and couldn’t believe how easy it was. Only took a couple of minutes.

    Posted 10 years ago
    neninja
    Free Member

    You only need end caps if it’s a Pro3 or Pro2 Evo.

    If you have an older Pro2 you need the kit with end caps and a new axle.

    Posted 10 years ago
    zippykona
    Full Member

    Job done less than 2 minutes.
    Thanks y’all.

    Posted 10 years ago
    Scamper
    Free Member

    Is converting to 12×142 just end caps too for pro2 evo?

    Posted 10 years ago
    neninja
    Free Member

    Is converting to 12×142 just end caps too for pro2 evo?

    Yes you need the X12 end caps

    Posted 10 years ago
Viewing 8 posts - 1 through 8 (of 8 total)

The topic ‘Converting my hope hub to 10mm qr.’ is closed to new replies.

Overview Chat Bike Members News Women