Viewing 7 posts - 1 through 7 (of 7 total)
  • Can somebody point me in the direction of the tools to service…
  • neilsonwheels
    Free Member

    …Hope pro2 hub bearings please.

    And while we are at it Mavic Cosmos as well.

    Cheers.

    hot_fiat
    Full Member

    The bearing drifts are on crc, as is the freehumb seal tool, though this isnt really necessary if yer careful. There’s different drifts for front and rear. Hope have videos on YouTube for servicing both front and rear.

    PeterPoddy
    Free Member

    Hammer and screwdriver to get the bearings out.
    Hammer and a couple of sockets to put them back in again.

    somafunk
    Full Member

    I use a hammer and suitable punch to remove the bearings, i refit them with a suitable sized socket and hammer.

    No need for special tools

    neilsonwheels
    Free Member

    A hammer and sockets it is then. Now wheres the best place for bearings.?

    deadkenny
    Free Member

    Old bearing on top of new if replacing, socket on top of old bearing to avoid damaging the new.

    Alternative to a hammer: threaded rod + wing nuts or similar and big washers = DIY bearing press.

Viewing 7 posts - 1 through 7 (of 7 total)

The topic ‘Can somebody point me in the direction of the tools to service…’ is closed to new replies.