Noticed on my Anthem that’s about 2 months old that the rear wheel is closer to the nds seatstay that the ds one by a few mm. Took tyre off and had a look and it does look about 2-3mm towards that side. Frame alignment seems fine, tried the bit of string round headtube and through both dropouts and distance from centre of seat-tube to string same each side so frame alignment is fine, as I’d expect on a new Giant !

Will drop bike in to LBS who supplied it methinks. any ideas ?

Thanks

Flip your wheel over and put it in the other way to check dishing? Think you have to remove mech for it to fit..

^^^ now that’s a good idea, assuming the rotor doesn’t get in way etc etc , might have a look, ta