these type
looking for something as an alternative to the o rings
Bike Forum
alternative bar and helmet mounts for magic shine/ deal extreme lights ?
-
Posted 7 months ago #
-
Expect lots of ppl to tell you your fussing over nothing:
http://singletrackworld.com/forum/topic/magicshine-et-all-bike-light-handlebar-mountsI haven't followed this up admittedly, as I already have one mount I swapped from my P7 to me XML light.
Posted 7 months ago # -
Also take a look here:
http://forums.mtbr.com/lights-diy-do-yourself/handlebar-brackets-739992.htmlThe Marwi mounts looked about the best option off-hand:
http://www.hoffmanamps.com/MyStore/perlshop.cgi?ACTION=enter&template&thispage=BikeLights&ORDER_ID=!ORDERID!Posted 7 months ago # -
cheers zippy,
have been experiencing some slippage on my rigid bike with os bars
Posted 7 months ago # -
your fussing over nothing:
I agree
A few wraps of self-amalgamating tape has mine holding rock steady in all conditions with the 'O' rings
Posted 7 months ago # -
i did this mod.. works a treat and is cheep as chips
[/url]]handle bar quick release mod
scroll down youll see it
Posted 7 months ago # -
will give the tape ago for a quick fix,
cheers craig 1975
Posted 7 months ago # -
I've got some stick on velcro you can have* that'll stop it moving.
*I'll swap it for two Nates.
Posted 7 months ago # -
you have a deal stu
Posted 7 months ago # -
For a helmet mount I use the same technique I use for my Exposure Flash as the mount is similar - get a cork cut a flat on it lengthways don't take too much off, then put the cork flat side to the helmet and put the rubber band around the cork and through the helmet and back to the light.
Posted 7 months ago # -
very inventive myheadsashed, and I happen to have quite a few corks
Posted 7 months ago # -
just done that cheers
Posted 7 months ago # -
is the a uk source of o rings anywhere?
Posted 7 months ago # -
I found that an old Cateye ABS mount will screw on in place of the O ring mount then just fitted the other mount to the bars. Works a treat. No good if you havn't got an old set of Cateye lights though obviously!
Posted 7 months ago # -
dobo, cut a 1cm cross section of inner tube and fold it in half. Mine came with the O-rings missing, so this is what I used. Worked just fine.
Posted 7 months ago #
Reply
You must log in to post.
